Ubuntu ssd health3/30/2023 If Selective self-test is pending on power-up, resume after 0 minute delay. SMART Selective self-test log data structure revision number 1Īfter scanning selected spans, do NOT read-scan remainder of disk. # 2 Short offline Completed without error 00% 4702. # 1 Short offline Completed without error 00% 5617. Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error SMART Self-test log structure revision number 1 ![]() Vendor Specific SMART Attributes with Thresholds: SMART Attributes Data Structure revision number: 16 SCT capabilities: (0x003d) SCT Status supported. Recommended polling time: ( 533) minutes. SMART capabilities: (0x0003) Saves SMART data before enteringĮrror logging capability: (0x01) Error logging supported. Self-test execution status: ( 0) The previous self-test routine completedĬapabilities: (0x5b) SMART execute Offline immediate.Īuto Offline data collection on/off support. Offline data collection status: (0x80) Offline data collection activity Warning: This result is based on an Attribute check. SMART overall-health self-assessment test result: PASSED SMART Status not supported: Incomplete response, ATA output registers missing SMART support is: Available - device has SMART capability. SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s) Sector Sizes: 512 bytes logical, 4096 bytes physicalĭevice is: In smartctl database ĪTA Version is: ATA8-ACS (minor revision not indicated) Smartctl 7.1 r5022 (local build)Ĭopyright (C) 2002-19, Bruce Allen, Christian Franke, = START OF INFORMATION SECTION = As mentioned earlier, different systems will generate different outputs. Logical Unit WWN Device Identifier: 500003964bc01970Īn example of a complete smartctl output from a drive is shown below also for reference. more than 508min for ENHANCED SECURITY ERASE UNIT. More than 508min for SECURITY ERASE UNIT. * SMART Command Transport (SCT) feature set * READ_LOG_DMA_EXT equivalent to READ_LOG_EXTĭevice-initiated interface power management * Device automatic Partial to Slumber transitions ![]() * Host automatic Partial to Slumber transitions * Host-initiated interface power management * Device Configuration Overlay feature set R/W multiple sector transfer: Max = 16 Current = 16ĭMA: sdma0 sdma1 sdma2 mdma0 mdma1 *mdma2 udma0 udma1 udma2 udma3 udma4 udma5Ĭycle time: no flow control=120ns IORDY flow control=120ns Standby timer values: spec'd by Standard, no device specific minimum Transport: Serial, ATA8-AST, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0ĬHS current addressable sectors: 16514064
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |